£3.99
This cylinder inlet kit attaches to the bottom of the cylinder and consists of a wing burr, a rubber seal and a tail/inlet.
This cylinder inlet kit attaches to the bottom of the cylinder and consists of a wing burr, a rubber seal and a tail/inlet. Only suitable for the Aston beer engine. Comes with: Y thread open nut L/Y thread washer L/Y thread – 1/2″ tail end
| Manufacturer | Harry Mason Ltd |
|---|---|
| Type | Cylinder Spares |
A primary mounts on the cylinder and brings the high bottle pressure down to a usable working pressure. A secondary sits downstream and lets you trim the pressure to individual lines that need different settings.
The most common cause is working pressure set too high, which over-carbonates the beer. Check the low-pressure gauge, not the bottle gauge. Warm beer and a dirty line will do the same thing, so rule those out too.
No. The valve fittings differ by design so that the wrong regulator cannot be fitted. Use the regulator made for the gas you are running.
Reviews
There are no reviews yet.